Asis Electromagnetic Wave products with integrated electronic board

Asis

Electromagnetic Wave products with integrated electronic board

To The Amazing Wave!
"Asis" in The Wave of The
"Asis" developed by Dr. Shuhiro Maruyama is an Electromagnetic Wave product with a built-in electronic board.
It is made of copper wire, resistance, toroidal coil, diode, core, FR4, silicon, electron beam crosslinking soft flame retardant polyolefin resin.

\11,000


About Asis

・ Surfaces with protrusions in the center can remove electromagnetic noise and control the magnetic field components in electromagnetic waves.

・ On the opposite side, electricity passing through the electronic components is exhausted, and it can be processed even if a large capacity static electricity flows.

It has become.

・ It can be used for both human body and electronic equipment.

How to use

When sticking to the body or equipment, please stick so that the surface with the protrusion is outside.

The image is a shape sample. In fact, it is coated with a tube, so please check the shape of the protrusion and use it.

※ There is no problem even if you stick it from the top of the clothing.

When pasting on the arch, please stick it for 30 minutes to 1 hour as a guide.

Please pay attention

  • ・If you feel any incident, remove it.
  • ・Do it when you are sitting, and do not stick it when standing. The base may be damaged.
  • ・Should you observe any abnormalities such as itchiness, please stop using.
  • ・ If it gets wet, it may discolor, but there is no problem with the product.
  • ・Please remove it when you take a bath or enter the sauna.
  • ・Keep out of reach of infants.
  • ・Please note that it will be damaged if you give a strong impact.
  • ・ This product cannot be repaired because it is a high-density electronic circuit.

Details

Product TypeElectromagnetic wave countermeasure products
IngredientsCopper wire, resistance, toroidal coil, diode, core, FR4, silicon, electron beam crosslinking soft flame retardant polyolefin resin